SER130 - Centrifugal Disassembly & Reassembly
Class Description
CDR is designed to teach experienced service mechanics how to properly disassemble both low and high-pressure centrifugal compressors, including Models 19XL, XR and EX. Techniques and procedures for using precision instruments are taught for determining clearances, fits, and tolerances of various bearings, seals and components. Students also review compressor lubrication, motor cooling, and capacity control. Because this course is lab oriented with enhanced student/instructor contact, attendance is limited and early registration is recommended.
Upon completion of this course, participants will be able to:
- Use special tools for measuring clearances
- Define standard sequence for disassembly of compressor
- Compare actual clearance and minimum/maximum design clearance
- Perform factory recommended assembly procedures
A cumulative score of 70% is required to pass this course. The score is a combination of attendance, class participation, and a demonstration of skills and knowledge through quizzes and/or work sessions.
Mandatory Prerequisite: SER120 (Centrifugal Fundamentals)
Note: Electrical control systems are not covered in this course.
| Length: | 4 -Days | ||||
| Cost: | $2,925.00 U.S. | ||||
| Certifications: |
|
Register for SER130 - Centrifugal Disassembly & Reassembly
Click on column header to sort, BOLD = Confirmed Class
| Class | Location | Start Date | Class Length (Days) | Register For Class |
|---|---|---|---|---|
| SER130 | Syracuse, NY | 02/13/12 | 4 |  |
| SER130 | Syracuse, NY | 04/23/12 | 4 | |
| SER130 | Syracuse, NY | 06/11/12 | 4 | |
| SER130 | Syracuse, NY | 08/20/12 | 4 | |
| SER130 | Syracuse, NY | 10/15/12 | 4 | |
| SER130 | Syracuse, NY | 12/03/12 | 4 | |
